The Newman's Energy Machine
By JL Naudin/M.David
created on 06/12/98 - JLN Labs - last update on 06/21/98
06-21-98 - Additional comments from JL Naudin
In the two diagrams above you can see :
The first diagram shows three curves :
1-a) The BLUE
curve (the input
current) is the real current flow
INPUT measured accross a 100 ohms resistor connected in series
with the coil.
1-b) The RED
curve (the "inductor
charging" current) is the
current needed for FILLING the COIL with magnetic energy while
the voltage is maintained constant. The magnetic energy in the
coil is Wm=0.5*L2
after 5*Tau = 5*L/R about 68 ms
1-c) The GREEN
curve (the "magnetomotive"
current) is the current GENERATED by
the rotation of the magnet through the coil. You may notice that
the shape of the curve has the SAME shape than the voltage
generated in the coil shown in the "free run" diagram.
This confirms the fact that this current is the real
"magnetomotive" current.
Today, I think personnaly that the best way to tap electrical
power on the Newman's coil is to use the ENERGY CONVERSION
PROCESS (ELECTRICAL -> MECHANICAL -> ELECTRICAL). The use
of two different kinds of energy (ELECTRICAL/KINETIC) is needed
for obtaining a good "REGAUGING" process and thus by
this way, a good effciency....
The KEY to this type of machine is to "charge" the coil while producing mechanical work. By this way you will be able to pump "free energy".
Don't forget that IF you load the shaft of the machine for extracting usable power, this will slow the turn speed, so YOU NEED to readjust the pulses timing sequence. You must use an oscilloscope for monitoring the current/voltage input and adjust the pulse duration so that the current pulse will be the same as shown below.
So, I think that the best way to build a good electrical overunity
generator is to connect a conventional
electrical generator on the main shaft of the Newman's Machine.
This is the feeling that I have today....
Link to the Additional comments (06-22-98)
If you need more informations or if you have any suggestions send me your Feedback
Email
: JNaudin509@aol.com
Return to the Newman's Machine Main page