The Lifter1 replicated successfully
by Andrejs Pukitis ( Latvia , Lettonia )

created on January 8, 2002 - JLN Labs - Last update January 8, 2002
All informations in this page are published free and are intended for private/educational purposes and not for commercial applications

Dear Jean-Louis

I am sending to you pictures of Lifter 1 replica.
Experiment was succesfull. At first there was problems with discharge between electrodes, but after aplying oil on the wire and foil edge discharges stoped.

Lifter specification:

Edge length 150mm
Weight 1.4g
Height 100mm
Foil width 40mm
Distance between wire and foil edge 33mm
Wire diam. 0.25mm
Supports made from balsa
Powered with  ViewSonic 14 monitor

Best regards

Andrejs Pukitis
Riga,
Latvia (Lettonia)

See also the :

Lifters builders and tests feed-back

Return to the Lifters Builders page