How to build the ELG-Hat v1.0
By Jean-Louis Naudin
created on May 21th, 2000 - JLN Labs - Last update May 22th, 2000

The Frolov's ELG-Hat is based on the T-Shaped capacitor built and designed by Alexander Frolov, it uses an improved Biefeld-Brown effect. This special design improves significantly the thrust and needs only few kV (5-10 kV) compared to the high voltage (30-250 kV) required by the original experiment of T.Townsend Brown. The Frolov's T-Shaped capacitor experiment has been fully presented in the Frolov's web site and also in the Electric Space Craft journal (issue 30, page 30 ( March 2000 )).

The ELG-Hat v1.0 construction procedure :

Step 1 :

Cut a 120 mm disk and a 220x20 mm rectangle in a 3mm polystyren foam sheet. You use a common CD as a template...

Step 2 :

Roll up carefully the rectangular strip on a bottle so as to make a 70mm cylinder, it is recommended to cover the foam with an adhesive rubber before. Glue with epoxy the cylinder on the main disk as shown in the photo below.

Step 3 :

Cut a 50 mm disk and a 120mm ring in an aluminum sheet ( commonly used for cooking ) as shown in the photo below.

Step 4 :

Glue the aluminum disk and the ring on the hat shaped device as shown in the photo below. The ELG-Hat v1.0 is now finished and ready for testing....

Return to the ELG-Hat experiment

See also :

Documents references :

Email : JNaudin509@aol.com

Return to the Advanced Propulsions Researches page