TORSION "FINGER SHOCK" PHENOMENON 1999 new_techn@zmail.ru The "shape effect" The "shape effect" produced by torsion fields can be felt by most people (without any detectors). For instance, try to make (or have somebody make) a skeletal wire pyramid having the following proportions. The base of the pyramid is a square. If the side of this square is equal to 1, then the height of a pyramid is equal to 0.618. That's the proportions of the Great Pyramid, the pyramid of Cheops exactly.) The pyramid may consist of edges only, e.g. it can be made of copper wire. The height of the pyramid (e.g. the segment of copper wire that connects the top of the pyramid and the center of its base) should be made also. If the side of the base of the pyramid has the size 20cm, then the height = 12.36 cm. The central wire is attached to the apex, and extends downwards to the center of the base, and the lower end of this wire attaches to nothing. OK to use solder to construct this. To prevent curving of the wires, use thick wires (2mm - 4mm diameter.) Hold the pyramid by its vertical wire, and orient it so its edges face the cardinal points. After several minutes of holding the pyramid by three fingers (thumb, index, middle) by its vertical wire (the fingers should be placed at 1/5 - 1/3 of the height from its lower point), most people feel "the torsion shock": cold or heat, pricking in the hand, etc. And there is no need to squeeze the vertical wire too strong, otherwise you'll feel not torsion shock, but simple pain caused by pressuring the fingers. Thus the so-called "passive" torsion generator can be created easily. But to create an intense torsion radiation, an "active" generator is needed. The torsion field generated by "passive" generators is a rather weak static torsion field. And moreover, "playing" with the passive torsion generators is dangerous. A.A.Beridze-Stakhovsky has developed generators based upon crystals that could be "programmed" mentally. Use care, because the reverse action is also possible.